Biaxial underwater accelerometer, rated to 650psi, 100 mV/g sensitivity, ±10% tolerance, low-profile, side-exit integral cable, case isolated

Miniature underwater accelerometer rated down to 650 psi, 10 mV/g sensitivity, wide frequency range, titanium case, top exit 10' integral J6 cable, case isolated

Miniature underwater accelerometer, 650 psi rating, titanium case, case isolated, top exit integral 10’ blunt cut J6 cable, 100 mV/g sensitivity, ±5% tolerance

Epoxy, Versilox, A-Paks, 406 / ACC. #17, enough for approx. 5-7 vibration sensor mounting bases

Vibration data source with MQTT output, IEPE to digital converter, 4 channels of vibration, tachometer (RPM) input supported for applications requiring rotational speed reference

Spot face tool for accelerometer mounting, 1.25” diameter w/ integral pilot drill for 1/4-28 hole, adjustable drill depth

Accelerometer coupling grease, silicone, 1.5 cc tube, Dow Corning [DC 111]

Grease for accelerometer mounting, silicone, 5.3 ounce tube, Dow Corning [DC 111]. *The acid and alkaline resistant SILGREASE can be used to assist in temporary walkaround mounting applications. It offers radiation resistance and is electrically insulating, even in moist environments. *Before stud mounting an accelerometer, a coupling fluid should be applied to the mating surfaces. The coupling fluid protects the mounting surface and optimizes the frequency response by increasing the coupling stiffness.

Accelerometer mounting stud adapter, adapts 10-32 thread to 1/4-28 thread, 0.315 inches, stainless steel

Short accelerometer mounting stud, 0.26 in, 10-32 UNF both ends, stainless steel

Vibration transmitter, loop-powered 4-20 mA vibration sensor, 3 user-configurable measurement bands, HART protocol, MIL-C-5015 connector

Velocity transmitter, loop-powered, 3 user-configurable measurement bands, HART protocol, M12 connector

Flat magnetic mounting base, 40 lb force, 1/4-28 tapped hole, non-isolated, 1” diameter

Flat accelerometer magnetic mounting base for use on flat surfaces, 15 lb force, 10-32 tapped hole, non-isolated, 0.75" diameter

Field configurable vibration transmitter with MODBUS support, IEPE sensor input, 2 x 4-20 mA output, built-in web server, up to 2 x analysis bands, alarm relay, supports single and dual output sensors

Field configurable vibration transmitter, IEPE sensor input, 2 x 4-20 mA output, built-in web server, up to 2 x analysis bands, supports single and dual output sensors

Factory configured vibration transmitter, IEPE sensor input, 2 x 4-20 mA outputs, supports single and dual output sensors

Installation kit for crimping cables to 6Q(I), 6QA(I), and 6GQ(I) connectors, each kit contains tools and supplies to assemble a maximum of approximately 75 connectors.
1. One 2 oz tube of A43012 epoxy will pot approximately 25 6Q connectors.
2. A61065 mixer tubes are disposed of after one use.

4-channel cable termination junction box for IEPE accelerometers, BNC jacks, NEMA 4X rated industrial enclosure, cable grips

2-channel cable termination junction box for IEPE accelerometers, BNC jacks, NEMA 4X rated industrial enclosure, cable grips